International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed

ISSN: 2319-7064


Downloads: 119

Research Paper | Mechanical Engineering | Iraq | Volume 4 Issue 9, September 2015


A Comparison of the Heat Transfer Performance of a Hexagonal Pin Fin with Other Types of Pin Fin Heat Sinks

Eaman Hassan Muhammad


Abstract: In this study, the heat transfer performance of hexagonal pin-fin heat sinks is compared with various commonly used fin geometries in laminar forced Convection. Overall the numbers of models are carried out during this study 8 different model. In other words, 4 models in in-line arrays and the other in staggered arrays, which were round, square, rectangular and the case study hexagonal. In order to compare these various geometries, a set of standard conditions was required, the basic conditions used here (3.3mm) hydraulic diameter and (6.6mm) pitch were the same in all shapes. The ratio (PL/PW) was chosen to be one. The Analysis was simplified by some major assumptions. The fluid in the domain is air. The compressibility effects are ignored due to the low air speed. Heat transfer and fluid flow were assumed to be two-dimensional, with identical velocity and pressure distribution in the z-direction. The ratio of solid to fluid thermal conductivity for aluminum and air is around 8360, permitting the fins to be modeled as isothermal surfaces rather than conjugate solids. Numerical simulations are performed using FLUENT 6.3. The CFD simulations were carried out on a two-dimensional computational domain bounded by planes of symmetry parallel to the flow. The air approach velocity was in the range of 0.165 to 4.5m/s. A comparison of heat transfer performance and pressure drop is presented. In general, for the given pressure gradient and flow rate, the hexagonal fin geometry yield a higher Nusselt number in comparison to square fins, and a lower Nusselt number in comparison to circular fins. And it can be noted that the staggered hexagonal fin geometry gave the heat transfer performance like inline circular performance at most Reynolds numbers in the range considered here.


Keywords: Electronic Cooling, Computational Fluid Dynamics, laminar flow, Pin fin Heat Sink Electronic Cooling, pin Fin, Heat sink, CFD laminar flow


Edition: Volume 4 Issue 9, September 2015,


Pages: 1781 - 1789


How to Download this Article?

You Need to Register Your Email Address Before You Can Download the Article PDF


How to Cite this Article?

Eaman Hassan Muhammad, "A Comparison of the Heat Transfer Performance of a Hexagonal Pin Fin with Other Types of Pin Fin Heat Sinks", International Journal of Science and Research (IJSR), Volume 4 Issue 9, September 2015, pp. 1781-1789, https://www.ijsr.net/get_abstract.php?paper_id=SUB158461

Similar Articles with Keyword 'Electronic Cooling'

Downloads: 105

Research Paper, Mechanical Engineering, India, Volume 4 Issue 4, April 2015

Pages: 2188 - 2192

Experimental Analysis on Effect of Design Parameters on the Performance of Single Loop Pulsating Heat Pipe

Someshwar S. Bhakre | Md. Rafik Sajjadahmad Choudhari

Share this Article

Downloads: 137

Research Paper, Mechanical Engineering, India, Volume 5 Issue 7, July 2016

Pages: 1317 - 1323

Optimal Design Methodology of Rectangular Heat Sinks for Electronic Cooling under Natural Convective and Radiative Heat Transfer

Abhishek Soi [2]

Share this Article
Top