Rate the Article: Multi Standard Reconfigurable Receiver Architecture for Wireless Systems, IJSR, Call for Papers, Online Journal
International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed

ISSN: 2319-7064

Downloads: 118 | Views: 330

Research Paper | Electronics & Communication Engineering | Syria | Volume 6 Issue 3, March 2017 | Rating: 6.7 / 10


Multi Standard Reconfigurable Receiver Architecture for Wireless Systems

Khaled Yazbek


Abstract: The existence of a large number of wireless standards motivates the investigation of a multi-standard wireless receiver architecture that uses the same hardware in meeting performance requirements. This paper presents an architecture of a reconfigurable receiver operating in both Low-IF and Zero-IF modes for GSM-1800 and UMTS-2100 wireless standards. The reconfigurability in the RF front-end part is achieved by a reconfigurable filter based on a dual mode resonator with the possibility of using MEMS switches to tune the center frequency and the bandwidth of the preselect filter. System-level analysis and derivation of block-level specification for the specified standards are developed to design the receiver. Simulation results for both system-level analysis of the reconfigurable receiver and circuit design of the reconfigurable filter are presented and discussed.


Keywords: multi-standard receiver, reconfigurable dual mode resonator filter, system performance simulation


Edition: Volume 6 Issue 3, March 2017,


Pages: 2134 - 2139



Rate this Article


Select Rating (Lowest: 1, Highest: 10)

5

Your Comments (Only high quality comments will be accepted.)

Characters: 0

Your Full Name:


Your Valid Email Address:


Verification Code will appear in 2 Seconds ... Wait

Top