Rate the Article: An Experimental Investigation on Cement Brick Using Coconut Fiber and Partial Replacement of Cement by Saw Dust, IJSR, Call for Papers, Online Journal
International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed

ISSN: 2319-7064

Downloads: 2 | Views: 32 | Weekly Hits: ⮙2 | Monthly Hits: ⮙2

Experimental Result Paper | Civil Engineering | India | Volume 14 Issue 4, April 2025 | Rating: 4.6 / 10


An Experimental Investigation on Cement Brick Using Coconut Fiber and Partial Replacement of Cement by Saw Dust

Dr. K. Arumugam, V. Shanthosh Kumar


Abstract: Normally cement bricks are widely used for making temporary and permanent civil structures. The aim of this study is to find out the utilization of Saw Dust Ash as a construction material in civil engineering works as a partial replacement of cement. The mix ratio of cement and sand is 1: 5 and water cement ratio of 0.6. Whereas the Coconut fiber is at constant percentage of 0.4% of the volume to be casted. Three range of curing period of 7 days, 14 days and 28 days are considered in the present study of Cement brick with replacement of cement by 0%, 10%, 20% and 30% using Saw Dust Ash (SDA) and Coconut fiber as additive. Mixes with different percentages of SDA are casted. It has been decided to make three different types of conventional specimens with partial replacement of cement with SDA on a percentage of 10%, 20% and 30% in cement brick. Brick mould size 190 x 90 x 90 (mm).


Keywords: Saw dust ash, M Sand, Cement, Coconut Fiber


Edition: Volume 14 Issue 4, April 2025,


Pages: 1203 - 1208



Rate this Article


Select Rating (Lowest: 1, Highest: 10)

5

Your Comments (Only high quality comments will be accepted.)

Characters: 0

Your Full Name:


Your Valid Email Address:


Verification Code will appear in 2 Seconds ... Wait

Top