Rate the Article: Evaluation of Compressive Strength and Basic Compressive Stress of Clay Brick Unreinforced Masonry by Prism Test, IJSR, Call for Papers, Online Journal
International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed

ISSN: 2319-7064

Downloads: 134 | Views: 369

Research Paper | Civil Engineering | India | Volume 4 Issue 5, May 2015 | Rating: 6.8 / 10


Evaluation of Compressive Strength and Basic Compressive Stress of Clay Brick Unreinforced Masonry by Prism Test

Deepa A. Joshi, R. K. Jain


Abstract: The compressive behavior of clay brick unreinforced masonry has been studied. As Masonry is normally provided for resisting compressive forces, compressive strength is the basic and important property of masonry and it is always required for design, repair or retrofitting of Masonry structures. Masonry constitutes of two different materials, bricks and mortar. The experimental results of bricks, mortar and brick masonry prisms are presented here with brief description of testing procedure. The basic compressive stress of unreinforced masonry prisms determined experimentally have been compared with the basic compressive stress of the same obtained by using IS 1905-1987. The failure mechanism of prisms under uniaxial compressive load has been discussed.


Keywords: Bricks, Mortar, Masonry, Compressive Strength


Edition: Volume 4 Issue 5, May 2015,


Pages: 913 - 916



Rate this Article


Select Rating (Lowest: 1, Highest: 10)

5

Your Comments (Only high quality comments will be accepted.)

Characters: 0

Your Full Name:


Your Valid Email Address:


Verification Code will appear in 2 Seconds ... Wait

Top