Rate the Article: Voltage Regulation of Non Linear Load Using STATCOM with Fuzzy Technique, IJSR, Call for Papers, Online Journal
International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed

ISSN: 2319-7064

Downloads: 112 | Views: 328

Research Paper | Electrical Engineering | India | Volume 4 Issue 1, January 2015 | Rating: 6.4 / 10


Voltage Regulation of Non Linear Load Using STATCOM with Fuzzy Technique

V. Bala, Dr. K. Elango


Abstract: In distribution systems, sudden change in load draws non-sinusoidal currents and causes the load harmonics, excessive neutral currents creates disturbance and changes in Power factor. Static Synchronous Compensator (STATCOM) is used to provide reactive power to the transmission line. In this paper proposes with Fuzzy Logic Controller (FLC) to tune PI controller gain values under different operating condition. Tuned values operate with PI controller and provides gate signal to voltage source converter which decides amount of reactive power to be injected into bus. Power factor value also improved. This method not affected by the initial gain settings, changes of system conditions and produces better and desired response. By providing reactive power and power factor correction system performance increased and also improves voltage regulation.


Keywords: Fuzzy logic controller, PI controller, STATCOM, Voltage regulation, Power factor correction, Reactive power compensation, non linear load


Edition: Volume 4 Issue 1, January 2015,


Pages: 1181 - 1186



Rate this Article


Select Rating (Lowest: 1, Highest: 10)

5

Your Comments (Only high quality comments will be accepted.)

Characters: 0

Your Full Name:


Your Valid Email Address:


Verification Code will appear in 2 Seconds ... Wait

Top