Downloads: 113
Research Paper | Mechanical Engineering | China | Volume 4 Issue 12, December 2015
Design and Simulation of Parallel Manipulator for Vehicle Driving Simulator
Khalid Ali Abdelaziz Ali | Liu Ying [3]
Abstract: A 3-Dof RPS parallel manipulator is selected in order to realize the motion of the driver simulator. For every limb, the structural designs are carried, which include the screw shaft and nut calculation, the load calculation, the motors selection, and so on. According to calculation, a model is established by using UG 6.0. modeling simulation in ADAMS software It supplied the basis for the further research.
Keywords: degree of freedom, joints desgin, nut selection, motor specifications selection, desgin and modeling, simulatiom using ADAMS
Edition: Volume 4 Issue 12, December 2015,
Pages: 1988 - 1994
Similar Articles with Keyword 'degree'
Downloads: 3 | Weekly Hits: ⮙1 | Monthly Hits: ⮙1
Research Paper, Mechanical Engineering, Nigeria, Volume 10 Issue 8, August 2021
Pages: 912 - 921Roughness Factor and its Implications, with Respect to Some Pressure Sensitive Adhesives, A Case Study of 3 Different Adhesives on 5 Mild Steel Plates with Varying Degrees of Roughness at the Surfaces
Ogbu Chika C | Ayogu Vincent | Okpe Bernard
Downloads: 3 | Weekly Hits: ⮙2 | Monthly Hits: ⮙2
Research Paper, Mechanical Engineering, India, Volume 3 Issue 6, June 2014
Pages: 2846 - 2847Experimental Investigation of Different Material Surface Morphology on Formation of Transfer Layer
M. Basavaraju [3] | Maharudra [4]