International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed

ISSN: 2319-7064


Downloads: 141 | Views: 252

Research Paper | Mechanical Engineering | India | Volume 6 Issue 7, July 2017 | Popularity: 6.5 / 10


     

Effect of Process Parameters on the Performance of Micro-EDM

Vasantha Prasath N, Mohanraj R, Nandhakumar M


Abstract: Electrical discharge machining (EDM) is an important process in the field of micro machining. However, a number of issues remain to be solved in order to successfully implement it in an industrial environment. One of these issues is the processing time. This paper investigates the optimization of machining parameters for Material Removal Rate and over cut in micro EDM. In one case, the parameters are selected to achieve the highest material removal rate (MRR). In the other case, the lower over cut is targeted. Some of the main difficulties linked with micro EDM are caused by the high wear occurring on the electrode. The study focuses on a specific combination of electrode and workpiece material and proposes a typical method for micro EDM process.


Keywords: Electrical Discharge Machining, Orthogonal Array, Taguchi Method, S/N Ratio, 304 Stainless steel


Edition: Volume 6 Issue 7, July 2017


Pages: 629 - 634



Make Sure to Disable the Pop-Up Blocker of Web Browser




Text copied to Clipboard!
Vasantha Prasath N, Mohanraj R, Nandhakumar M, "Effect of Process Parameters on the Performance of Micro-EDM", International Journal of Science and Research (IJSR), Volume 6 Issue 7, July 2017, pp. 629-634, https://www.ijsr.net/getabstract.php?paperid=7071711, DOI: https://www.doi.org/10.21275/7071711



Similar Articles

Downloads: 50 | Weekly Hits: ⮙1 | Monthly Hits: ⮙1

Research Paper, Mechanical Engineering, India, Volume 10 Issue 1, January 2021

Pages: 1124 - 1127

Effect of Various Parameters on Machining of EN-31 in Wire Electrical Discharge Machining

Rajat, Shiv Kumar

Share this Article

Downloads: 105

Research Paper, Mechanical Engineering, India, Volume 3 Issue 11, November 2014

Pages: 2865 - 2869

Dry Sliding Wear Behaviour of Al-Si-Ti Alloys Using Taguchi Method

Ganpat B. Jambukar, Dr. Y. R. Kharde

Share this Article

Downloads: 116

Research Paper, Mechanical Engineering, India, Volume 6 Issue 11, November 2017

Pages: 1833 - 1842

An Experimental Investigation and Optimization of Electrical Discharge Drilling for Small Hole Drilling with High Aspect Ratio

Ashok Kumar, Sandeep Kumar Rawal

Share this Article

Downloads: 117

Research Paper, Mechanical Engineering, India, Volume 4 Issue 1, January 2015

Pages: 2699 - 2702

Optimization of End Milling Parameters on Surface Roughness of Die Steel HCHCr by Taguchi Method

M. S. Harne, Ravikumar L. Shirsat

Share this Article

Downloads: 119 | Weekly Hits: ⮙1 | Monthly Hits: ⮙1

Research Paper, Mechanical Engineering, India, Volume 5 Issue 3, March 2016

Pages: 1988 - 1994

Optimization of Process Parameters of Friction Stirs Welding of Aluminum Alloys (6061) Using Taguchi Method

Siva Rama Krishna R, Pavan Kumar T

Share this Article
Top