Downloads: 60 | Views: 180
Research Paper | Material Science | Mali | Volume 9 Issue 9, September 2020 | Popularity: 6.6 / 10
Comparison between Three (3) New Cotton Varieties (A, B and C): Technological Characteristics of the Fibers and its Spinnability Index
Dr Awa Soronfe Doumbia, Dr Mamadou Togola, M. Mouctar Baba, Amadou Ali Yattara
Abstract: In Mali, several studies and research have been undertaken in favor of varietal improvement of the cotton plant, which until then have focused on, among other things, the improvement of varietal species, the increase in productivity and the technological quality of fibers. The variety choice is now made at national organizational structure on the cotton sector from production up to commercialization level on the basis of variety trials conducted by national research. The choice of varieties is made according to the objectives of the moment and the requirements of the spinners. The general objective of this study is to evaluate the technological characteristics of the fibers of the cotton varieties G3 A, G3 B and G3 C with a view to their transformation through the spinning. The technological characteristics of the new varieties are generally good for the samples analyzed. In fiber technology, they are at the same level as the values sought or deemed appropriate by the textile industry. However A variety is the best in terms of fibers technological parameters (it is ranking in the first floor for four (4) parameters on six (6) parameters. Therefore its spinnability index is the best (SCI =139). Otherwise, concerning waste quantity it shows the least (ME % = 3.74) compared to two others. Finally, with regard to the varietal improvement objectives, the study showed that these must be clearly identified from economic and technical concerns, to lead to the development of specifications specifying the limits of the physico-technical parameters beforehand determined.
Keywords: cotton, varieties, fiber, technological characteristics, spinning
Edition: Volume 9 Issue 9, September 2020
Pages: 691 - 696
Make Sure to Disable the Pop-Up Blocker of Web Browser
Downloads: 226 | Views: 509
Material Science, India, Volume 8 Issue 4, April 2019
Pages: 7 - 10Optical Characterisation of CdTe Thin Films
Desh Bandhu Sharma
Downloads: 167 | Views: 342
Material Science, Congo, Volume 8 Issue 11, November 2019
Pages: 66 - 74Composition and Stability of a Copper Metallurgy Slag Based Environmentally Friendly Geopolymer Cement
Kabange B. Numbi, Martin T. Mpinda, Sissou Zakari, Kisimba T. Ngobola, Ngoie D. Songe
Downloads: 162 | Views: 344
Material Science, India, Volume 7 Issue 7, July 2018
Pages: 378 - 382Microstructure and Mechanical Properties of Low Carbon Steel Alloy During Normalizing, Annealing & Tempering Heat Treatment Processes
Gali Sai Swaroop, Mallampati Revanth Kumar, Bandi Chaitanya Kiran Kumar
Downloads: 151 | Views: 481
Material Science, India, Volume 9 Issue 3, March 2020
Pages: 829 - 832Studies of Cerium Doped L-Alanine Alaninium Nitrate NLO Crystal
M. Esthaku Peter, Seblewongel Getachew, Betelhem Alemu, Eleni Binalfeus, Getahun Leliso, Tirngo Abay
Downloads: 148 | Views: 287
Material Science, India, Volume 7 Issue 7, July 2018
Pages: 220 - 224Effect of Mn Concentration on Structural, Optical Properties and Humidity Sensing Activity of Tinoxide Nanoparticles
M. Sabarilakshmi, K. Janaki