Downloads: 2 | Views: 269 | Weekly Hits: ⮙2 | Monthly Hits: ⮙2

Research Proposals or Synopsis | Industrial Engineering | India | Volume 12 Issue 5, May 2023 | Popularity: 4.7 / 10

Rate This Article!      

Design and Analysis of Composite Shaft Using Ansys Simulation

Ibsar Khan, Prof. Dr. Sachin Meshram

Abstract: In this project, designing a drive shaft with composite materials. The traditional drive shaft is made of single material like steel and in two parts, which relate to the help of universal joints this causes increase in weight and sometimes failure at joints at high loads. Hence designing a shaft in single part without any joints in between. The shaft designed is lighter in weight which will help in increasing efficiency. After designing the shaft, analyzing the traditional steel shaft and the composite shaft using analysis tools like Catia and Ansys, and compare the values of both the shafts, this was theoretical checking. Experiment is conducted to check the torsional forces in both the shafts on a torque tester and comparison is done to check whether the composite shaft will carry loads like steel drive shaft without failure.

Keywords: Composite shaft, Design, Drive Shaft, Automobile, Ansys, Model, Light vehicle

Edition: Volume 12 Issue 5, May 2023

Pages: 784 - 786

DOI: https://www.doi.org/10.21275/SR23504142239

Make Sure to Disable the Pop-Up Blocker of Web Browser

Click to Cite this Article

Similar Articles