Design and Response Characteristics of Electronic Control System on Hydraulic-Driven Mole Plough
International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed

ISSN: 2319-7064


Downloads: 138 | Views: 468 | Weekly Hits: ⮙1 | Monthly Hits: ⮙1

Research Paper | Electrical Engineering | Indonesia | Volume 2 Issue 11, November 2013 | Popularity: 6.5 / 10


     

Design and Response Characteristics of Electronic Control System on Hydraulic-Driven Mole Plough

M. Hariansyah, Radite P.A Setiawan, Desrial, Dewa Made Subrata


Abstract: Design and response characteristic of electronic control system on mole plough is the part of dissertation. Mole plough is used to construct the subsurface drainage channels on farms, to improve the absorption of water logging which caused plant deterioration. In the design, mole plough was directly mounted to hydraulic cylinder. The pressure to drive hydraulic cylinder piston was taken from tractor with capacity 55 kW using hydraulic hose. The problem that needs solving was how to observe the response characteristics of electronic control system on mole plough. This paper presented an alternative system came from the combination of mechanics, hydraulics, and electronics systemto lift and lower the mole plough based on received input sensor. The main parts of the system are hydraulic proportional controller, which is the first order control system, and convert the rotational angle of stepper motor to valve control openings in order to operate the velocity of hydraulic oil, and Electronic Control Unit (ECU) whichproduces the valve opening angle in the form of stepper motor rotation. Through the design analysis, response time in generating the valve opening system to drive the hydraulic cylinder piston was 3, 75 seconds at 89, 2 valve opening angle from the desired set point 15 valve opening, the maximum error in steady state condition was 2, 1 %.


Keywords: Mole plough, electronic control system, hydraulic system, control valve, stepper motor


Edition: Volume 2 Issue 11, November 2013


Pages: 1 - 6



Make Sure to Disable the Pop-Up Blocker of Web Browser


Text copied to Clipboard!
M. Hariansyah, Radite P.A Setiawan, Desrial, Dewa Made Subrata, "Design and Response Characteristics of Electronic Control System on Hydraulic-Driven Mole Plough", International Journal of Science and Research (IJSR), Volume 2 Issue 11, November 2013, pp. 1-6, https://www.ijsr.net/getabstract.php?paperid=02013337, DOI: https://www.doi.org/10.21275/02013337

Similar Articles

Downloads: 108

Research Paper, Electrical Engineering, Sudan, Volume 5 Issue 5, May 2016

Pages: 2153 - 2156

Microcontroller Based Master Slave Communication for Electrical Stepper Motor

Rayan Mohamed Hamid, Eltahir Mohamed Hussein

Share this Article

Downloads: 127

Research Paper, Electrical Engineering, India, Volume 4 Issue 5, May 2015

Pages: 446 - 449

Position Control of Hybrid Stepper Motor Using PIC16F877A Microcontroller

Pratkisha N.Balai, Jimit A.Talati

Share this Article

Downloads: 133

Case Studies, Electrical Engineering, India, Volume 7 Issue 10, October 2018

Pages: 913 - 914

Development of Variable Reluctance Stepper Motor Controller for PV System

Vineet Shekher

Share this Article

Downloads: 141

Research Paper, Electrical Engineering, India, Volume 6 Issue 6, June 2017

Pages: 997 - 1001

Gas Leakage Alerting and Accident Control System Using GSM/GPS Technology

K. Rekha, R. Kiruthiga

Share this Article
Top